Determine a suitable height for installation. Peepholes come in two parts.
So never open the door unless you know whos on the other side.
How to install a peephole in a door. Installing a Peephole Viewer in Your Door. Most commercial doors are 1 34 inches thick while. Install the lens from the exterior of the door and then screw the barrel in from the interior.
Drill the door hole insert the lens from the inside and the sleeve from the outside then screw them together for a peephole. Drill the door hole insert the lens from the inside and the sleeve from the outside then screw them together for a peephole. With the door open hold the outdoor piece in place with one hand.
The first step is to choose the right peephole for your house. Mark the installation position. This will leave you with a hole in your door suitable for the camera youre installing.
This is an affilliate link and i get a small amount if you order through this link and t. Installing a peep hole viewer in your door is a simple DIY project that can add loads of safety and security to your home. Here is a link to Items and equipment I may have used in this video.
Measure the thickness of your door using a tape measure. Step-by-Step Start by finding the height that you want the viewer to be at. As sturdy deadbolts and reliable window locks have become more common some crooks have learned that the easiest way to get into a house is to ring the doorbell.
If you do have a peephole you should remove it completely. You can either take the average of everyones height in. Start with a 18-in.
Most entry doors are often fitted. How to install a peephole in a metal exterior door Select the place where it will be located and make the marking. With your other hand screw the tightening nut onto the shaft to secure the indoor piece to the door.
You should measure the width of your door then wrap the tape at the same. Scenario number two starts by you choosing a suitable place to put the camera. Stick the painters tape to avoid damage of the.
Then you drill either a 12mm or 14mm hole inside. If you dont have windows that let you see whos knocking install a door peephole. Installing a Peephole The peephole itself is a tube consisting of two parts.
How to Install a Peephole in a Metal Door Step 1. Wrap tape around the base of your drill bit. Use the peephole key to tighten the nut until its fastened securely.
Theres the lens which has a threaded cylinder attached and theres the barrel which is threaded on the inside. Spiral bit at the center of the peephole location. Drill the hole for peephole on both sides.
Peepholes come in two parts. Its diameter should be slightly larger than the diameter of the door viewer. Locate the peephole in the center of the door and approximately 58 in.
When the call button is pressed the device activates the LCD display takes a photo and starts video recording. I purchased a peephole from Home Depot. The electronic peephole consists of a doorbell and a video camera that are attached to the outside of the door as well as an LCD display for the inside.
Choose a peephole of stainless steel or brass to avoid rust and corrosion on exterior doors. Run the drill at full speed and press lightly to bore a clean hole. Once you have chosen a suitable peephole for your door.
How to install a peephole in a metal door is a video about the installation of a peep hole in a front door. Most peepholes require 12 in.
Source : pinterest.com