Reverse order to install. Chevy 350 power steering bracket diagram posted on january 28 2015 by admin 2003 chevy trailblazer power steering lines diagram luxury 350 wiring info the drilled to mount the power steering bracket can be used as a template for marking holes use 3 8 16 tap and drill 11 deep 350 power steering bracket the 1947 present chevrolet gmc.
Clean grooves on all pulleys taken apart n put back together new alt new watr pump new idler.
How to install power steering pump and brackets chevy 350. Install the four water pump pulley bolts. Mount the lower support brackets that came with your kit. Power Steering Pump Mounting Bracket for 283 305 327 350 383 400 SB Chevy Engine.
Attach the water pump pulley part number 19368329 to the water pump. This long water-pump V-belt setup ran from 1969 to well into the mid-80s with various water-pump mount layouts different power-steering pumps and. If your power steering pump came equipped with a mounting stud at the rear of the pump use a 1116 wrench to remove the mounting stud from the pump unit fig.
Power steering pumps for the 400 and 350 chevy engines are held in place in a bracket and brace mouted to the enginecheck around on line on internet look up power steering pump mounting brackets for 400 chevy engineyou need the mounting bracket in order to install power steering pump. Poop Trucks power steering gave out. C 2024 shipping estimate.
Make sure the bracket confines the hoses away from the steering shaft. New Other C 4492. But when you look down the face of all the pulleys the PS pulley looks canted and thats the puley that the belt appears to be riding up on thus torching the belt on the front facing side of the belt.
A new or rebuilt power steering pump will most likely not come with a pulley attached. Install the water pump and gaskets on the front of the engine using the four bolts part number 9442012 to retain the pump. Place the hose bracket around the PS hoses slide the bracket into position on the pump body and run the bolt through the bracket and into the pump body finger snug.
WATER PUMP AND PULLEY. Remove nut from pressure line mounting on alternator bracket. Torque these bolts to 40 Nm 30 lb.
After driving it for 3 weeks with no power steering I finally decided to fix it. Power Steering Bracket Installation Chevy Small Block Long Water Pump 1. Remove power steering pump mounting bolts.
Source : pinterest.com